A crooked or off balanced door.
My garage door opens crooked.
The door might be hard to open and close due to it binding.
By pushing the door back into position you should have made the vertical track straighten.
One of the most likely culprits when you have a crooked garage door is a broken torsion spring.
One question some homeowners ask is why their garage door closes then immediately reverses to the open position.
If your garage door is closing fully and then reversing to open again then it may be due to a problem with the close limit switch.
Push the door push the door back to adjust the door and get the center aligned again.
Warping of the door will also cause it to run crooked and stick in the tracks.
5adjust the lift cable.
This will cause the unit to stick.
Your garage door is likely the largest opening on your home s exterior so it s important to have the peace of mind that it is functioning properly.
If the opener is adjusted properly the garage door will move up and down in an even motion.
Regular adjustment will prevent a crooked door.
A garage door that s out of alignment can be very dangerous.
With the door propped open take the s hook out of the support and tighten or loosen the cable as needed.
Here are three possibilities.
Garage doors which have become crooked or wonky may be suffering from jumped cables which is when one or both cables have loosened from the cable drums and started to unwind.
To make fine adjustments try adjusting the lifting cable instead of the spring.
In order to fix this you ll want to make small changes to the close limit setting until the door opener knows to stop once the door has reached the floor.
The cable is attached to the door and runs to an s hook that attaches to the track support.
There may be a large gap of space between the stop molding and the door.
Without proper adjustment however the unit may run along the tracks unevenly.
It is possible that the vertical track down the side has gone out of alignment and shifted due to a slightly loose lag screw.
Jumped cables can be caused by the door hitting an object during operation or if it has been lifted too fast while being opened manually.