The over dig is necessary to make sure that the outside edges of the stone remain stable during and after the installation.
Paver stone steps diy.
Using your excavator excavate to a depth of 9 inches image 2.
Start by digging out the area where you d like to place your stone paver patio.
Ensure your steps all end up at the same height and that each step is 15 inches deep from front to back.
Setting paver steps into a hillside is one way to turn a slope into a usable walkway that is both attractive and convenient.
Lay out the landscaping fabric.
Mark the perimeter of the path using spray paint increasing the size by 6 inches for the over dig image 1.
The paver should sit about 1 4 in.
It ll tamp down later.
Once you know these dimensions you can work out how many steps you will build.
This will aid in rainwater drainage under the.
Begin digging your patio area.
Stone or brick pavers require no mortar when properly set so the labor required to install them is considerably less than pouring concrete.
How to build a patio.
Next add a layer of landscaping fabric on top of the dirt.
Use sand to feather the slight slope in the gravel to meet the level steps evenly.
Then divide the net size of each step by the size of your pavers to see how many you need.
How to build steps out of stone pavers step 1.
A diy stone paver patio tutorial step 1.
Rake the sand back with a 2 4 maintaining an even slope photo 11.
Take care not to step in the sand or compress it.
Lay down a layer of landscape fabric to cover the excavated area.